Floppy Drive Connector (Cn2) - Aaeon PCM-4335 Manual

Floppy drive connector (CN2)

You can attach up to two floppy disks to the PCM-4335's on-
board controller. You can use any combination of 5¼" (360 KB
and 1.2 MB) and/or 3½" (720 KB, 1.44 MB, and 2.88 MB) drives.
The PCM-4335 CPU card comes with a 34-pin daisy-chain drive
connector cable. On one end of the cable is a 34-pin flat-cable
connector. There are two sets of floppy disk drive connectors,
one in the middle, and one on the other end. Each set consists of a
34-pin flat-cable connector (usually used for 3.5" drives) and a
printed-circuit board connector (usually used for 5.25" drives).
Connecting the floppy drive
1. Plug the 34-pin flat-cable connector into the floppy disk
connector.
2. Attach the appropriate connector on the other end of the cable
to the floppy drive(s). You can use only one connector in the
set. The set on the end (after the twist in the cable) connects
to the A: floppy. The set in the middle connects to the B:
floppy.
Pin assignments
The following table lists the pin assignments for the floppy disk
connector:
Floppy drive connector (CN2)
Pin
1~33 (odd)GND
4, 6
10
14
18
22
26
30
34
Signal
Unused
Motor enable A
Driver select A
Direction
Write data
Track 0
Read data
Disk Change
Pin Signal
2 High density
8 Index
12 Driver select B
16 Motor enable B
20 Step pulse
24 Write enable
28 Write protect
32 Select head
Chapter 2 Installation 11