Table of Contents
Advertisement
5. Repeat steps 3 and 4 for all the hubs in the stack.
When you have four hubs stacked together, make sure the following conditions exist
(see Figure 3-4):
− The Cascade Up connector on the top hub is empty.
− The Cascade Down connector on the bottom hub is empty.
− The Terminator LED is lit on the top and bottom hub.
− The Terminator LED is not lit on the middle hubs.
Figure 3-4. Four hub stack configuration
6. Connect the power cords to the AC power receptacles on the rear panel of all the hubs
in the stack.
7. Connect the power cord to the power outlet.
8. Continue with the steps in "Verifying Your Installation" later in this chapter.
Installation
Installation Guide for the Model FE508 and FE516 Fast Ethernet Hubs
3-9
Advertisement
Table of Contents
