NETGEAR FE508 Installation Manual page 20

Installation Guide for the Model FE508 and FE516 Fast Ethernet Hubs
Figure 3-2. Installing the hub in an equipment rack
4. Connect the devices to the ports on the hub using Category 5 UTP wiring and connectors to
the RJ-45 connectors.
Refer to Appendix C, "Fast Ethernet and Cabling Guidelines," for wiring rules and guidelines.
5. When installation for each hub in your stack is complete, connect the power cord(s) first to
the power entry receptacle on the hub rear panel and then to the wall.
6. Continue with the steps in "Verifying Your Installation" later in this chapter.
3-6 Installation