NEC P452H User Manual page 98

TIP:
• With the projector's Ethernet/HDBaseT port, remote control is not available when the projector is in the standby mode (serial
communications is not available). (Remote control becomes available when the projector's power is on). The 2 (two) methods
below can be used to turn on the projector's power when it is in standby mode.
1. The projector can be operated by connecting the computer and projector to the network (on the projector, using the LAN port
and PC Control Utility application with [STANDBY MODE] set to [NETWORK STANDBY] (→ page 101).
Computer (for projector control)
2. The projector can be operated by RS232C serial communication (On this projector, use the PC CONTROL terminal and the
application software, PC Control Utility, and select [PC CONTROL] for the [SERIAL PORT]) with [STANDBY MODE] set to
[NETWORK STANDBY].
Switching hub, etc.
5. Installation and Connections
Example of a transmitter
DC IN
HDBaseT
Video device with HDMI output
Ethernet/HDBaseT
87
Computer (for output)