Nissin i40 Instruction Manual page 8

Turn on the flash unit
Press the On/ Off switch and Pilot button
turns red, showing the unit is turned on.
Indicator Lamp A on.
In a few seconds, the Pilot button turns
green. The i40 is ready to shoot.
For a test flash, press the Pilot button.
To turn off the flash unit manually, press
the On/ Off switch for 1 second.
MENU DIAL
i40 Flash Mode and Functions
Rotate the dial to select a function.
...
Video Light
Built in video light with 9 steps of output level adjustment
...
Full Automatic Mode
Flash light is fully controlled by the camera for the
most proper exposure.
...
TTL Program Mode
Flash light is automatically controlled by the camera
but the flash exposure value can be compensated.
...
Manual Setting Mode
Manual Mode -Selecting the desired manual power
on the flash unit.
...
Slave Digital
...
Slave Film
RMT
...
Wireless Remote Mode (RMT-M / RMT-TTL / RMT2-TTL)
RMT M = MANUAL REMOTE / RMT TTL = TTL REMOTE / RMT2 TTL = TTL REMOTE 2
Placing multiple numbers of flashes (slave flash) off camera and controlling the
creative TTL lighting or Manual power output.
*If [WL CTRL] (wireless control flash mode setting) in the MENU setting is set to
[CTRL], the remote group of the wireless remote setting will operate the same
whether it is REMOTE or REMOTE 2.
**You can perform wireless flash photography while controlling the lighting ratio
between a maximum of 3 groups including the controller and two groups of
off-camera flash units.
***RMT-M mode - Control the power compensation by rotating the power dial.
7