Nissin i40 Instruction Manual page 15

Setting slave flash i40
Switch i40 on and while the ready lamp is on, rotate the Function dial to select
desired mode.
When flash is set to SD or SF mode, rotate the Power dial to select different flash
power levels of 1/256 – 1/128 – 1/64 – 1/32 – 1/16 – 1/8 – 1/4 – 1/2 – 1/1 (Full)
power.
When the flash is set to the Wireless mode, the power level will be controlled by
the Master flash. The remote works on all channels and with group RMT-M*/
RMT2-TTL
RMT-TTL/
*Output power set in Flash
Set slave flash at any place and direct the flash head as you desire. Slave
sensor may not respond to the master flash in a poor sensing situation such
as extremely bright condition.
Use the flash stand included. Place i40 on to the flash stand which can be placed
either on a flat surface, or on the tripod by the screw.
NOTE
When set to auto zoom which is default position to 35mm ; Press and hold the
on/off switch 3 seconds until the colour of Pilot button change according to the
Manual zoom area.
Metal type accessory shoe is not recommended since it may give electric damage
on the electrical contact of the flash hotshoe.
Shooting the subject
Set the camera for flash shooting mode. Point at the subject and shoot. The
slave flash will synchronize to the master flash and gives additional lighting
from the different direction you desired.
Automatic shut off function is
however in effect. It automatically
turns-off when not in use for over
60 minutes.
The zoom setting position is
automatically set for the focal length
of 35mm while using i40 as a slave
unit. And it can be manually
changed.
.
14