Nissin i40 Instruction Manual page 14

RMT
i40 has a wireless remote flash system as a slave unit. You can enjoy creative
flash photography with multiple lightings from the various directions. 3 remote
modes are provided, Slave Digital (SD) for digital pre-flash system; Slave Film
(SF) for analogue flash system and Wireless remote
All channels and groups RMT-M/ RMT-TTL/ RMT2-TTL may be used.
SD: In this mode, i40 synchronizes to the pre-flash system. The master flash is
to be set at TTL mode.
SF: In this mode, i40 synchronizes to the traditional single flash system. The
master flash is to be set at manual mode. Studio lighting system synchronizes
to this mode. This mode is also available for open flash, and for a standard
flash in the market.
Press the on/ off switch to power on.
Indicator Lamp A on.
Rotate the Function dial to "SD" / " SF" mode then
Indicator Lamp A blinking.
Indicator Lamp B on.
You can select the power by rotating the Power dial : 1/256﹣
1/128 – 1/64 – 1/32 – 1/16 – 1/8 – 1/4 – 1/2 – 1/1 (Full) power.
Wireless Remote: For Sony system: In this mode, i40 synchronizes to the
wireless remote flash system. For remote All channel group RMT-M/
RMT-TTL/ RMT2-TTL digital flash.
Press the on/ off switch to power on.
Indicator Lamp A on.
Rotate the Function dial to "
AF-assist light blinking.
* RMT-M mode - to control the power compensation by rotating the power dial
Placing multiple numbers of flashes (slave flash) off camera and controlling the
creative TTL lighting or Manual power output.
Wireless Remote Flash
RMT-M RMT-TTL
" "
for wireless remote.
RMT
RMT2-TTL
" " " mode then
13