Transmission Unit - Kranzle junior 120 Operating Instructions Manual

Transmission unit

No. Description
1 Gehäuseplatte
2 Öldichtung 12 x 20 x 6/5
3 O-Ring 83 x 2
4 Plungerfeder
5 Federdruckscheibe
6 Plunger 12 mm
7 Distanzbüchse
8 Taumelscheibe 12,5°
10 Axial-Rillenkugellager 3-teilig
12 Innensechskantschraube M 8 x 25
13 Ölschauglas
14 O-Ring 14 x 2
15 Öleinfüll-Stutzen
16 Ölverschlußschraube rot
17 O-Ring 21 x 1,5
18 Sprengring 12 mm
22
Qty. Order No.
1 43.080
3 43.081
1 43.039
3 43.040
3 43.082 1
1 43.083
3 43.084
1 41.028-12,5
1 43.486
4 40.053
1 42.018 1
3 43.445
1 43.011
1 43.437
3 43.085
3 43.095
Description
Brief operating instrucions
are fittet to the machine (numbers 1 - 6)
1. Connect the hogh pressure hose with spray gun
and machine.
2. Connect the suitable water supply.
3. Flush the air from the pump (open and close the spray gun
several times).
4. Make the electrical connection ( 110-115 Volt AC).
5. Switch on the machine while the spray gun is open and
commence cleaning.
6. After completing the work, completely empty the pump. (switch
the motor on for approx. 20 sec. without the suction and
pressure hoses).
- Only use clean water ! Protect from frost !
CAUTION !
Please pay attention to the regulations of your waterworks company.
In accordance with DIN 1988, the machine may not be directly connected to
the public drinking water supply lines.
A brief connection however is permissible according to DVGW (German
Associatin for Gas and Water Affairs) if a tube ventilator with reflux valve
(Kränzle Order-No. 41.016 4) is built into the water supply.
Also indirect connection to the public drinking water supply lines is
permissible by way of free emission in accordance with DIN 1988, part 4;
e.g. by using a reservoir with a float valve.
Direct connection to a non-drinking water supply line is permissible.
High pressure hose and spray device
The high pressure hose and spraying device suplied with the machine are
made of high grade material, they are also optimized for the machine and
marked as required by appropriate regulations.
If replacement parts are required, only such parts that are
authorized by the manufacturer and which bear the markings
required by appropriate regulations may be used. The high
pressure hose and spray device must be connected in a pressure-
tight manner. The high pressure hose may not be driven over,
pulled excessively, or twisted. The hose may under no
cicumstances be pulled over sharp edges, since otherwise the
guarantee is automatically void.
7