Maintenance; Boat Care - RS Feva Owner's Manual

6.

MAINTENANCE

6.1 Boat Care

The RS Feva is made using Comptec PE3, a three-layer polyethylene construction.
This is stiff and light, but will dent if subjected to point loading. The boat should be
supported ashore on an approved RS trolley, as the hull may distort if not supported
properly. For long-term storage, it is better to support the boat on a rack, in slings, or
another type of support that spreads the weight and avoids point loads. The hull can
also be stored on the transom, but never store the boat for long periods on its side.
When dealing with a marine environment, equipment gets wet; this in itself is not a
problem. The problem starts when moisture is trapped for any length of time.
Therefore, it is very important to store the boat properly ashore.
Keep your dinghy drained and well ventilated
Ensure that the boat is stored with the bow raised to allow water to drain away.
Wash with fresh water
Fresh water evaporates far more quickly than salt water so, if your dinghy has been
sailed in salt water, rinse it thoroughly. The fittings will also work better if regularly
washed.
Any stubborn marks on the hull can be removed with a light detergent, such as
washing up liquid. Always test cleaning products on a small, inconspicuous part of
the deck before applying to the whole boat.