Technical Specification - Blackstar id:60tvp Owner's Manual

USB Audio
Standard audio drivers are used to connect the amplifier to a PC or Mac, no specific
drivers are required.
The amplifier will appear as an audio capture device within recording software.
The output of the audio over USB can be changed via the Blackstar Insider software,
and can be one of the following:
 Speaker emulated stereo effected audio channels
 2 x mono audio channels
- Left – effected amplifier signal
- Right – unprocessed guitar signal
 Re-amping Mode
Re-amping
The amplifier can be switched into Re-amping Mode via Blackstar Insider software.
This is a non-storable setting and will be switched off either when the USB cable is
removed, or when the amplifier power is switched off.
When activated, Re-amping Mode allows the amplifier to accept a pre-recorded, dry
guitar signal via USB and return a fully processed audio signal. This return signal can
then be captured using recording software on the connected PC or Mac.
Firmware Update
Firmware updates are initiated via Blackstar Insider software. A new version of the
Blackstar Insider software will be released whenever an update is available. Each
update will take approximately 60-120 seconds.
When the amplifier is connected (via USB) to a version of the Blackstar Insider
software containing newer firmware, a message will be displayed, prompting you to
install the latest files. Whilst updating, the amplifier controls will be unresponsive. The
Tap LED flashes to indicate data activity during the update process.
The amplifier power should not be switched off during a firmware update. If the
amplifier is switched off during an update, the controls will be unresponsive after the
power is reapplied and the amplifier will produce no sound. The Tap LED will flash
to indicate that the amplifier contains no valid firmware.
The amplifier must be connected to the Blackstar Insider software to reinstall valid
firmware. The update process will start automatically if the Blackstar Insider software
detects that the amplifier is in this state.
20

Technical Specification

ID:60TVP
Power: 60 Watts
Weight (kg): 18
Dimensions (mm): 584(W) x 485(H) x 250(D)
Footswitch (not supplied): FS-4 latching footswitch, FS-10 footcontroller,
MIDI footcontroller
ID:60TVP-H
Power: 60 Watts
Weight (kg): 10.8
Dimensions (mm): 584(W) x 236(H) x 225(D)
Footswitch (not supplied): FS-4 latching footswitch, FS-10 footcontroller,
MIDI footcontroller
ID:260TVP
Power: 2 x 60 Watts (Stereo)
Weight (kg): 24.2
Dimensions (mm): 686(W) x 510(H) x 250(D)
Footswitch (not supplied): FS-4 latching footswitch, FS-10 footcontroller,
MIDI footcontroller
ID:100TVP
Power: 100 Watts
Weight (kg): 12.8
Dimensions (mm): 686(W) x 246(H) x 225 (D)
Footswitch (not supplied): FS-4 latching footswitch, FS-10 footcontroller,
MIDI footcontroller
21