Section 7 − Operating Auxiliary Equipment; Generator Power Receptacles And Circuit Breakers - Miller Electric PipePro 304 Owner's Manual

SECTION 7 − OPERATING AUXILIARY EQUIPMENT

7-1. Generator Power Receptacles And Circuit Breakers

!
If unit does not have GFCI recep-
tacles, use GFCI-protected exten-
sion cord.
.
Generator power decreases as weld
current increases.
1 240 V 50 A AC Receptacle RC1
RC1 supplies 60 Hz single-phase power at
weld/power speed. Maximum output is 12
kVA/kW.
2 120 V 20 A AC Duplex Receptacle
RC2
3 120 V 20 A AC Duplex Receptacle
RC3
RC2 and RC3 supply 60 Hz single-phase
power at weld/power speed. Maximum out-
OM-492 Page 28
5 1 2
SIMULTANEOUS WELDING AND AUXILIARY POWER
Weld Total
Current Power
In Amperes In Watts
350 11900
300 9600
250 7500
200 5600
150 3900
100 2400
50 1100
0 0
put from RC2 or RC3 is 2.4 kVA/kW.
4 240 V 30 A, AC Twistlock Receptacle
RC4
RC4 supplies 60 Hz three-phase power at
weld/power speed. Maximum output is 12
kVA/kW.
5 Supplementary Protector CB1
CB1 protects RC1, RC2, and RC3 from
overload. If CB1 opens, RC1, RC2, and
RC3 do not work. Place switch in On posi-
tion to reset.
6 Supplementary Protectors CB2 And
CB3
CB2 protects RC2 and CB3 protects RC3
from from overload. If CB2 or CB3 opens,
the receptacle does not work. Press button
to reset.
3 6
120 V Single-Phase Three-Phase
Receptacle 240 V
Amperes Receptacle Receptacle
Amperes
− −
16 5
38 15
40 30
40 35
40 40
40 45
40 50
7 4
8
240 V
Amperes
−
4
10
13
19
23
26
30
7 Supplementary Protector CB4
CB4 protects RC4 from overload. If CB4
opens, the receptacle does not work. Place
switch in On position to reset.
.
If a supplementary protector continues
to open, contact Factory Authorized
Service Agent.
Combined output of all receptacles limited
to 12 kVA/kW rating of the generator.
EXAMPLE: If 13 A is drawn from RC2 and
RC3, only 37 A is available at RC1:
2 x (120 V x 13 A) + (240 V x 28 A) = 12
kVA/kW
8 Generator Power While Welding
Table
213 263-B