Use And Maintenance - S&P GE 60 Installation Manual And Instructions For Use

Table of Contents

Advertisement

Available languages

Available languages

• If the evacuation tube is too short and it is necessary to join two or more tubes together,
make sure not to make the diameter narrower at the joints and avoid air leaks at the con-
nection point.
RECyCLING MODEL (RECyCLING Of THE AIR INSIDE THE HOOD) – fIG. 2
• If you want the recycling model in the kitchen you should request a series of active charcoal
filters from the supplier. For the assembling of the filter, bare in mind the Kit instructions. If
the Kit is not included ask the supplier for a supplementary one.
• The filters are not washable, they cannot be reused and the majority have to be replaced
every 4 months. The saturation of the the active charcoal filters depends on the amount of
prolonged use of the hood, the type of food cooked and the regularity of the cleaning of the
grease filter.
• The active charcoal filter should be applied to the extraction apparatus situated in the inside
of the hood opposite the motor (Fig. 6). Remove the mesh (Fig. 4-D) in order to carry out this
operation. Center and turn it 90 degrees until it reaches its limit.
ELECTRICAL INSTALLATION
• Make sure the mains voltage and frequency coincide with those on the characteristics plate
on the hood and the remote extraction unit.
• This device has been designed with Class II electrical shock protection, therefore do not
connect any cable to the earth connection.
• Connect the cables according to the following:
Brown = L (Live)
Blue = N (Neutral)
• If you want to connect the hood to a fixed socket, attach a standard plug to the cable, ap-
propriate for the current indicated on the characteristic plate on the hood (motor and lights).

4. USE AND MAINTENANCE

• The hood has a multi-position switch to select speed of the extraction It also has a switch
for the lights which illuminate the cooking area (Fig. 5).
A = Light control
B = Pilot light
C = Extraction speed control
• It is advisable to start the appliance before cooking and leave it operating for 15 minutes
after finishing cooking.
Attention: Before carrying out any maintenance or cleaning operations, always dis-
connect the hood from the mains.
• Correct operation of the hood depends on its regular maintenance, especially the grease
filter. The aim of the grease filter is to retain the particles of grease which are in the air; the-
refore it will get blocked after a time, which will vary depending on the specific use of the
appliance.
10

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ge 60 biGl 60Gl 60 bi

Table of Contents