Table of Contents
Advertisement
VLAN
VLAN All
Mirror Port : Users can configure LAN 1 as mirror port by choosing "Enable Port 1 as Mirror Port". All the
traffic from LAN to WAN will be copied to mirror port. Administrator can control or filter the traffic through
mirror port. Once this function is enabled, LAN 1 will be shown as Mirror Port in Physical Port Status, Home
page.
gather the connection speed and duplex mode. Therefore, if Enabled
Auto-Neg. selected, the ports setup will be done without any manual setting by
administrators.
This feature allows administrators to set the LAN port to be one or more
disconnected network sessions. All of them will be able to log on to the Internet
through the device.
Members in the same network session (within the same VLAN) can see and
communicate with each other. Members in different VLAN will not know the
existence of other members.
Set VLAN All port to be the public area of VLAN so that it can be connected to
other VLAN networks. A server should be constructed for the intranet so that all
VLAN group can visit this server. Set one of the network ports as VLAN All.
Connect the server to VLAN All so that computers of different VLAN groups can
be connected to this server. Moreover, the port where the administrator locates
must be set as VLAN All so that it can be connected to the entire network to
facilitate network management.
Gigabit SSL VPN Security Router User's Manual
- 58 -
Advertisement
Table of Contents
