Installation; Getting Started - Contest LED-Blaster User Manual

LED-BLASTER - 2 x 10W RGBW LEDs multi-beam animation effects

4 - Installation

The LED-BLASTER was designed to be attached to structures or on the ground, via an adapted support.
We strongly recommend to use a double hanging system with safety cable in case of failure of the main suspension
bracket. The safety cable must be able to bear 10 times the weight of the LED-BLASTER.
The installation must be performed by a qualified technician.
Please make sure that no one can reach the projector once it is set up.
Safety cable

5 - Getting started

Your LED-BLASTER is not equipped with any power switch.
As a result, your device is ready to go as soon as it is connected to an electrical outlet.
Once powered up, your LED-BLASTER will perform an initialisation before being fully operational.
If dipswitches are in automatic mode, it will launch its internal programmation by itself, however if a DMX signal is
detected via the DMX input it will await DMX information.
Hook clamp
English
Page 5