Memory Configuration; Pch Configuration; Pci Express Configuration; Pch Storage Configuration - Asus H110I-PLUS D3 User Manual

iGPU Multi-Monitor [Disabled]
This item allows you to empower both integrated and discrete graphics devices for the
multi‑monitor output. The CPU graphics shared system memory size is fixed at 64 MB.
Configuration options: [Disabled] [Enabled]
RC6(Render Standby) [Enabled]
Allows you to enable or disable Intel
iGPU power use when the system is idle. Configuration options: [Disabled] [Enabled]
DVMT Pre-Allocated [32M]
Allows you to select the amount of system memory pre‑allocated to DVMT 5.0 used by
the internal graphics device. Configuration options: [32M] [64M] [96M] [128M] [160M]
[192M] [224M] [256M] [288M] [320M] [352M] [384M] [416M] [448M] [480M] [512M]
[1024M]
DMI/OPI Configuration
This item allows you to control various DMI (direct media interface) to run at PCI‑E 2.0 speed.
DMI Max Link Speed [Auto]
Allows you to configure the DMI speed. Configuration options: [Auto] [Gen1] [Gen2]
PEG Port Configuration
Allows you to configure the PEG Port settings.
PCIEx16_1 Link Speed [Auto]
Allows you to configure the PCIEx16 speed for slot 1. Configuration options: [Auto]
[Gen1] [Gen2] [Gen3]

Memory Configuration

Allows you to configure the memory configuration parameters.
Memory Remap [Enabled]
Set this item to [Enabled] to support DRAM address remapping for 64‑bit operating
systems. Configuration options: [Enabled] [Disabled]
2.6.4

PCH Configuration

This item allows you to configure the PCI Express configuration settings.

PCI Express Configuration

PCIe Speed [Auto]
Allows you to configure the PCIe speed. Configuration options: [Auto] [Gen1] [Gen2] [Gen3]
2.6.5

PCH Storage Configuration

While entering Setup, the BIOS automatically detects the presence of SATA devices. The
SATA Port items show Empty if no SATA device is installed to the corresponding SATA port.
SATA Controller(s) [Enabled]
Enables or disables onboard the SATA device. Configuration options: [Disabled] [Enabled]
The following items appear only when you set the SATA Controller(s) to [Enabled].
ASUS H110I-PLUS D3
Graphics Render Standby support to reduce
®
2‑25