Event Reporting - Symbol MiniScan MS XX07 Series Integration Manual

Event Reporting

The host can request the decoder to provide certain information (events) relative to the
decoder's behavior. Enable or disable the events listed in
appropriate bar codes on the following pages. Parameter number format for these
parameters follows those shown in the Simple Serial Interface (SSI) Programmer's Guide
for parameters numbered 256 or higher.
Event Class
Decode Event
Boot Up Event
Parameter Event
Table 10-3. Event Codes
Non-parameter decode
System power-up
Parameter entry error
Parameter stored
Defaults set (and parameter event is enabled by default)
Number expected
Table 10-3
Event
Parameter Menus
by scanning the
Code Reported
01h
03h
07h
08h
0Ah
0Fh
10-113