Oven Door Removal; Door Disassembly; Oven Door Hinge; Blower Motor - Viking VGDO271 Service Notebook

DISASSEMBLY PROCEDURES

Oven Door Removal

1. Open oven door and remove screws securing door to
hinge assembly.
2. Place oven door in first stop position, then grasp
both sides and lift up off the hinge.
NOTE: Door hinges are spring loaded and will snap
closed if bumped. Avoid pinching fingers by
closing hinges completely until ready to mount
door back on the unit.
3. Reverse procedure to reassemble.

Door Disassembly

1. Remove oven door, see "Door Removal".
2. Remove screws on right, left, top, and bottom of
oven door.
3. Remove door liner from door assembly.
4. Remove screws securing inner glass support
securing glass and door handle.
5. Remove glass mounting bracket and glass window.
6. Remove screws securing heat door liner shield and
remove.
7. Reverse procedure to reassemble.
NOTE: When reassembling door, verify HB ll marking
on the glass is facing toward the heat (inside
of the oven).

Oven Door Hinge

1. Turn off power to unit.
2. Remove oven door, see "Door Removal".
3. Carefully open the hinge fully, and insert a wooden
dowel or screwdriver bit into opening marked A on
the following diagram.
4. Remove the top and bottom screws securing hinge
assembly to the front frame.
5. Slide the hinge assembly up and move top of hinge
towards rear of the range.
assembly through the frame opening.
6. Reverse procedure to reinstall oven door hinge
assembly.
Withdraw hinge
23

Blower Motor

1. Turn off and disconnect electrical and gas supplies
to the oven.
2. Open oven door and remove screws securing unit to
the wall.
3. Remove unit from cutout opening.
4. Remove screws securing top outer wrapper from the
unit.
5. Disconnect and label wire terminals connected to
blower motor.
6. Remove screws securing blower motor assembly to
bracket.
7. Reverse procedure to reassemble.
Vent Assembly
1. Turn off and disconnect electrical and gas supplies
to the oven.
2. Open oven door and remove screws securing unit to
the wall.
3. Remove unit from cutout opening.
4. Remove screws securing top and back outer
wrapper from the unit.
5. Remove screws securing vent assembly to unit.
6. Turn off and disconnect electrical and gas supplies
to the oven. Vent assembly and slowly maneuver
vent assembly away from unit.
7. Reverse procedure to reassemble.
Broil Ignitor
1. Shut off power and gas supply to oven.
2. Remove oven door and oven racks.
3. Unscrew broil ignitor wire cover mounting screw.
Remove cover.
4. Remove broil ignitor mounting screws. Pull ignitor
leads and connectors into oven cavity through hole
in broil chamber.
5. Disconnect ignitor wiring.
6. Reverse procedure to reassemble.
Broil Burner
1. Shut off power and gas supply to oven.
2. Remove oven door and oven racks.
3. Remove broil ignitor mounting screws. Remove
ignitor from broiler burner.
4. Remove broil burner mounting screws securing
burner to burner bracket.
5. Move burner up against burner bracket, push burner
towards rear of oven. Slide broiler burner out of
broil chamber.
6. Reverse procedure to reassemble.