Changing The Battery In The Wireless Speed Transmitter - Pro SCIO 3.3 Manual

CHANGING THE BATTERY IN THE WIRELESS
SPEED TRANSMITTER - PRO SCIO
The Wireless Speed Transmitter uses a 23A 12v Alkaline battery.
Under normal conditions, this battery should last approximately
one year.
Using a coin, turn the battery door counter clockwise until the
1.
door comes free.
Take care not to damage the O-ring seal for the battery
2.
compartment and carefully remove the old battery.
Place a new battery in the transmitter positive (+) side toward
3.
the battery door.
Place the battery door over the opening and tighten it down
4.
by using a coin and turning in a clockwise direction.
If the O-ring has been damaged, replace it before reinstalling
5.
the battery door.
Extreme care should be taken when replacing the battery to
ensure the unit remains fully water resistant. Failure to properly
replace the battery and correctly seal the unit may cause the unit to
become damaged and may void the warranty.
o33_35_41_eng.indd 7
7
11/21/07 12:25:30 P