Installing The Cooktop - GE PGP9830 Owner's Manual & Installation Instructions

INSTALLING THE COOKTOP

10
INSTALLING THE COOKTOP:
Lift the cooktop by the glass side edges as shown.
NOTE: Do not use the glass top vent opening to lift or move
the cooktop into position.
Lower the cooktop into the countertop opening, guiding it
countertop. Support from the underside and lower slowly.
Carefully remove your fingers one corner at a time to lower
the cooktop into position.
NOTE: Do not use Silicone RTV or caulk to bond cooktop
glass to countertop.
Once the unit is placed in countertop; visually inspect the
cooktop and counter, appearance or alignment concerns.
49-80516-3
Installation Instructions
CAUTION:
DO NOT LIFT FROM
VENT OPENING.
11
INSTALLING THE OPTIONAL
INSTALLATION BRACKETS
NOTE: Check for glass flatness in Step 9 before installing
optional installation brackets.
Cooktop
Screws supplied with
cooktop
To order optional installation brackets/thumb screws, call the
National Parts Center at 800.626.2002.
Order two of each part: WB02X11331 Bracket
WB01X10353 Screw
To install optional installation brackets:
Remove 2 screws on both sides under cooktop.
Align optional installation bracket under cooktop and reinstall
screws through the slot in the bracket. Do this on both sides of
the cooktop.
Thread the thumb screw through the hole in the bracket and
tighten to secure the cooktop to the countertop. Repeat on the
other side.
IMPORTANT: Turn thumb screw until it touches the bottom of
the countertop. Do not overtighten.
Optional installation
bracket and thumb
screw (not included)
Countertop
Thumb screw
25