Installing The Cooktop - GE PGP989 Owner's Manual And Installation Instructions

InStAllInG tHE CooKtoP

8
Lift the cooktop by the glass side edges as shown .
notE: Do not use the glass top vent opening to lift
or move the cooktop into position .
Lower the cooktop into the countertop opening,
guiding it into position . Glass is fragile—do not allow
it to drop onto the countertop . Support from the
underside and lower slowly .
Carefully remove your fingers one corner at a time
to lower the cooktop into position .
notE: Do not use Silicone RTV or caulk to bond
cooktop glass to countertop .
Installation Instructions
InStAllInG tHE CooKtoP
CAutIon:
Do not lIFt From
VEnt oPEnInG.
CHECKInG For FlAtnESS
9
Inspect the cooktop glass for rocking or uneven
gap on all four sides at the countertop surface .
Do not attempt to force the glass to meet the
countertop .
InStAllInG tHE oPtIonAl
10
InStAllAtIon BrACKEtS
notE: Check for glass flatness in Step 9 before
installing optional installation brackets .
Cooktop
Screws supplied with
cooktop
To order optional installation brackets/thumb screws,
call the National Parts Center at 800 . 6 26 . 2 002 .
Order two of each part: WB02X11331 Bracket
To install optional installation brackets:
Remove 2 screws on both sides under cooktop .
Align optional installation bracket under cooktop
and reinstall screws through the slot in the bracket .
Do this on both sides of the cooktop .
Thread the thumb screw through the hole in the
bracket and tighten to secure the cooktop to the
countertop . Repeat on the other side .
ImPortAnt: Turn thumb screw until it touches the
bottom of the countertop . Do not overtighten .
25
Check for
uneven gaps
Optional installation
bracket and thumb
screw (not included)
Countertop
Thumb screw
WB01X10353 Screw