Skoda Citigo Owner's Manual page 35

Memory

Read and observe on page 31 first.
The following data will be saved in two memory banks 1 and 2 .
▶
Average fuel consumption.
▶
Distance driven.
▶
Average speed.
▶
Driving time.
The selected memory is displayed at position
"1" - Single-trip memory
The memory collates the driving information from the moment the ignition is
switched on until it is switched off.
New data will also flow into the calculation of the current driving information if
the trip is continued within 2 hours after switching off the ignition.
If the trip is interrupted for more than 2 hours, the memory is automatically
erased.
"2" - Long-term memory
The memory gathers driving information from any number of individual jour-
neys up to a total of 19 hours and 59 minutes driving or 1999 kilometres driven.
The memory is deleted when either of these limits is reached and the calcula-
tion starts all over again.
Unlike the single-trip memory, the total-trip memory is not deleted after a pe-
riod of interruption of driving of 2 hours.
Select memory
Operation » page 31,
Fig. 25
Multi-function display - Display
example of the memory
» Fig. 25.
A
▶
Select the desired data to be displayed in the multi-function display.
▶
Confirm details again to select the desired memory.
Reset memory
Operation » page 31,
▶
Select the desired data to be displayed in the multi-function display.
▶
Select the desired memory.
▶
Reset the selected memory by pressing down on it for a long time.
Note
Disconnecting the vehicle battery will delete all memory data.

Read and observe on page 31 first.
The time is set as follows.
›
Select the time display on the instrument cluster
›
Press the button » Fig. 26 and keep it pressed down until the hour display
A
starts flashing.
›
To change the value, press the button
down the button.
›
Press button until it flashes to select the minute display.
A
›
To change the value, press the button
down the button.
›
Confirm the value entered by pressing the button
around 5 seconds. The setting is saved automatically (the value stops flash-
ing).
Fig. 26
Buttons in the instrument clus-
ter - variant 1
» page 31, Operation.
. To change the value quickly, hold
B
. To change the value quickly, hold
B
again, or wait for
A
Instruments and control lights
33