Medisana 77055 Instruction Manual page 23

changing the battery. This way you can turn on the thermometer for
ear/forehead measurement as described. However, it then switches off
completely.
Open the battery compartment by pressing the knob for opening the
2.5
battery compartment
Setting
battery compartment cover
the time
On/Scan button
reached (see Fig.).
You can now switch from the hour setting to the minute setting by
pressing the time setting button again
es. Adjust the minute setting in the same way that you adjusted the
hour setting. When you have set the time, press the time setting but-
ton
The display
ambient temperature (see Fig.).
Using the device as a room thermometer and clock constitutes
a continual measuring process, which significantly reduces the
battery service life.
• The thermometer is equipped with an encapsulated sensor
2.6
Before you
• The sensor
start to use
the device...
• Ear wax affects the measuring accuracy. If necessary, clean your ear
• If the ambient temperature exceeds the designated range of 16 °C
until the hour display flashes. The hours are set by pressing the
several times until the required hour setting is
again as confirmation (see Fig.).
of the device now alternates between the time and the
Special protection caps are not required.
of the thermometer must be kept clean and intact
at all times in order to guarantee that the measurements are ac-
curate.
and the sensor tip of the thermometer before measuring in order
to avoid erroneous measurements.
to 40 °C when the ambient temperature is being measured, "Err"
will appear in the display
with a pointed object and removing the
. Press the button for setting the time
. The minute display flash-
.
2 Start-up
15
GB
.