8" full range ceiling loudspeaker with dual concentric driver, 6" full range ceiling loudspeaker with dual concentric or ict driver, 5" full range ceiling loudspeaker with dual concentric or ict driver, 4" full range ceiling loudspeaker with dual concentr (69 pages)
12" full range ceiling loudspeaker with dual concentric driver and transformer for installation applications (26 pages)
Summary of Contents for Tannoy CMS 801 DC BM
Page 1
CMS 801 DC back-can Tannoy has a policy of continuous improvement and this specification sheet provides the latest information at the time of printing. All specifications may be subject to further change. Please contact the Tannoy website for the latest information.
CMS 801 DC BM DIMENSIONS Recommended torque setting: 1.5Nm CMS 801 DC PI DIMENSIONS Tannoy will not be held responsible for any damages caused by the improper installation of these loudspeakers. CMS 801 DC PI BACK-CAN DIMENSIONS TECHNICAL SPECIFICATIONS...
4. PRODUCT FEATURE IDENTIFICATION: 5. ACCESSORIES: Each product is supplied with the following accessories as standard: Conduit/Cable Clamp Tuning Port Euro Type Connector C-Ring Tile bridge kit Screws for mounting wings Note: A tile bridge kit Mounting Wings must always be used when installing into suspended ceiling tiles Rotary Switch...
Slide the speaker assembly through the hole and turn the screws to extend the mounting wings. Tighten the screws until a firm grip is achieved. If using a power driver, Tannoy recommends a torque setting of 1.5Nm. DO NOT OVERTIGHTEN! Slide the speaker assembly through the hole and turn the screws on the front of the speaker to extend the mounting wings.
5.4 INSTRUCTIONS FOR OPTIONAL PRE-INSTALLATION BACK-CAN (PI MODELS ONLY): An optional plaster (mud) ring bracket is available from Tannoy. This bracket is designed to be pre-installed into newly AN OPTIONAL PRE-INSTALL BACK-CAN IS AVAILABLE FOR ALL PI (PRE-INSTALL) MODELS. THIS BACK-CAN IS DESIGNED TO constructed, non-suspended ceilings.
6. WIRING AND SETTING UP: 7.1 CMS 801 DC BM DIMENSIONS: TEMPLATE HOLE CUTOUT SIZE: 295mm Open the wiring cover at the back of the speaker can to access the Euro type connector plug and socket. 327.8 286.4 310.5 [12.90"] [11.27"]...
Details of the Apparatus: Tannoy Contractor Loudspeaker number has been altered or removed. Work under warranty should only be carried out by a Tannoy Professional dealer or service agent. This warranty in no way affects your statutory rights. For further information please contact your dealer or distributor in your country.