Table of Contents
Advertisement
6.4 Setting device parameters
Requirement
Parameter
Possible values Description
Display
brightness
Leakage
alert
Energy saving
Key tone volume
Alarm volume
Alarm clock
volume
You can use the device parameters to set the brightness of the
display and the volume of the acoustic signals among other things
as you wish.
The therapy device is in Standby mode.
1. Press the menu button
2. Press the Device
3. Configure the required settings and confirm.
Here you can set the brightness of the display.
1
•
Level 1: Dark
2
•
Level 2: Normal
3
•
Level 3: Bright
Here you can set whether an alarm should be triggered in case
of a leak. This allows you to change the position of your mask
Off
at night. By doing so you avoid side effects or a reduced therapy
quality due to severe leaks.
On
If it is not possible to select this function, it must be enabled by
your physician or authorized dealer.
Here you can activate or deactivate whether the therapy device
automatically switches to Energy saving mode 15 minutes
Off
after the therapy has finished.
On
You save electricity if the therapy device is in Energy saving
mode during the day.
Here you can set the volume of the acoustic signal for every time
Off
a key is pressed or switch the signal off.
1
•
Level 1: Quiet
2
•
Level 2: Normal
3
•
Level 3: Loud
Here you can set the volume of the alarms.
1
•
Level 1: Quiet
2
•
Level 2: Normal
3
•
Level 3: Loud
Off
Here you can set the volume of the alarm.
•
Level 1: Quiet
1
•
Level 2: Normal
2
•
Level 3: Loud
3
6 Settings in the menu
.
field.
WM 100 TD
EN
65
Hide quick links:
Advertisement
Table of Contents
