Sony hdw-730 Operation Manual page 114

• When the camcorder power is switched off during recording in
Auto Interval Rec mode
• When you set the POWER switch to OFF, the camcorder will switch
off by itself after the tape has run for a few seconds to record the
picture data stored in the memory.
• If you remove the battery, unplug the DC cable, or cut power to the AC
3
adaptor while auto interval recording, the picture data shot and stored
before recording stops (maximum 5 seconds) will not be recorded. Do
not change the battery during auto interval recording.
• When tape runs out during auto interval recording
Note that the picture data (maximum 5 seconds) shot and stored before
the tape stops is not recorded if the tape runs out and the camcorder
stops.
Setting the Manual Interval Rec mode
There are two kinds of Manual Interval Rec mode:
• Single trigger mode
Setting the number of frames to be recorded at one shooting
(NUMBER OF FRAME) enables the camcorder to record the number
of frames preset each time the VTR START button or the VTR button
on the lens is pressed.
• Continuous trigger mode
Pictures are automatically shot by preset frames at preset intervals by
pressing the VTR START button or the VTR button on the lens.
Setting the single trigger mode
1
Follow the procedure in steps 1 to 5 in "Setting the Auto Interval
Rec mode" on page 3-29 to select LOOP/INTVAL REC on the
FUNCTION 1 page.
3-40
Chapter 3 Recording and Playback