Unpacking Instructions; Steamer Assembly - Conair CGS95A Instructions For Use Manual

UNPACKING INSTRUCTIONS

Place the box on a large, sturdy flat surface. Carefully remove the
appliance from the packing material. Keep all plastic bags away
from children.

STEAMER ASSEMBLY

Attaching the Telescopic Pole and Rotating Hanger
1. Turn the lock on top of base unit to unlock position and place
telescopic pole into opening. Turn clockwise to lock.
2. Fully extend the telescopic pole, making sure to lock the pole
upright by engaging the two clips, and hang the steam nozzle
from the cradle atop the 360 degree rotating hanger assembly.
3. Pull lower pants clips towards you and rotate clockwise to lock
into place.
4. This unit comes with a rotating hanger. To use the hanger,
simply place on top of pole firmly. Then tighten lower nut to
keep hanger upright or untighten to collapse hanger. It is now
in place to rotate 360˚. Hang your garment and steam away
wrinkles. Turn as you wish.
5. Attach the top pants clip bar to the rotating hanger by
inserting mounting pegs into the hanger's two keyhole
openings. Push in and pull down to lock. See instruction
booklet "Using pant clip system", Fig.3 for more details.
6. With telescopic pole now fully assembled, place the T-Nozzle
onto holder above the hanger.
7. When you are ready to steam, fill the water tank from the top
opening. Note, do not open the bottom cap as this is used for
cleaning or removing excess water only.
8. Plug the steamer unit into a standard 240V AC power outlet.
9. The bristle brush attachment easily snaps over the T-nozzle
for use. To use the creaser attachment, simply line up at base
and slide into back under T-nozzle and push firmly to attach.
See instruction booklet "Attachments" section figures 5 and 6
for more details.