Trouble Shooting - Conair CGS95A Instructions For Use Manual

Repeat the above procedure as many times as necessary until a
normal steam rate returns, usually 2–3 times. With each repeated
cycle, use a fresh solution of vinegar and water. Run one cycle
of fresh, cold water without vinegar through the unit at the
completion of decalcification before using the unit again to steam
garments.

TROUBLE SHOOTING

PROBLEM
Steamer fails to heat
No steam
Water drips from
nozzle
Poor steaming
performance
Dye on T-nozzle
Discoloring of fabric
POSSIBLE CAUSE
Steamer is not
plugged in
Water level is low
(beep will sound)
Condensation in
hose
1. Steamer is not
plugged in
2. Decalcification is
necessary
Fabric not
colorfast / Touching
T-nozzle to fabric
Dye on surface
of fabric needs
specialty treatment
and cleaning /
Fabric not suitable
for steaming
SOLUTION
Plug into power outlet
and switch product on
Switch product off and
refill water container
Hold the nozzle and
hose vertically and allow
water to drain back into
unit
1. Plug into power outlet
2. Follow steps for
decalcification
Clean T-nozzle
with household cleaner
and rinse with soap and
water
Some custom specialty
fabrics have dyes that
are NOT COLORFAST and
are not suitable for
steaming. Test fabric
for colorfastness in an
inconspicuous spot
before steaming