Install The Network Camera - Axis Q6032-C Installation Manual

AXIS Q6032-C/Q6034-C/Q6035-C Installation Guide

Install the Network Camera

The supplied multi-connector cable shall be used to comply with the IP66 rated design of the
camera.
1. Install the selected bracket (sold separately) according to the instructions supplied with the
bracket. If drilling is required, make sure to use drill bits, screws, and plugs that are appropriate
for the material. See www.axis.com for information on available mounting accessories.
2. Route the multi-connector cable through the bracket.
3. Hook the camera to the safety wire on the bracket.
4. Remove the protection cap covering the multi-connector cable connector on the camera.
5. Connect the multi-connector cable to the connector on the camera. Use the alignment
indicators to find the correct position.
Mounting example, wall bracket sold separately
6. Slide the unit holders on the camera into the slots on the bracket and rotate the camera unit.
7. Secure the network camera to the mounting bracket by fastening the 3 screws (Torx T30).
Slot for unit holders (3x)
Screw (x3)
Safety wire
Multi-connector cable
Alignment indicator
Alignment indicator
Page 19