Section 5 − Operation; Controls - Miller Electric DVI-2 R Owner's Manual

5-1. Controls

2
3
1 Voltage Control
Set Voltage control according to the
parameter chart for good starting point.
Turn control clockwise to increase voltage.
.
A complete Parts List is available at www.MillerWelds.com
SECTION 5 − OPERATION
2 Wire Speed Control
Set Wire Speed control according to the
parameter chart. Increase or decrease wire
speed to obtain desired bead profile and
travel speed.
1
3 Over Temp Light
If unit overheats, light turns on and output
stops. Allow unit to cool before resuming
operation.
OM-232 386 Page 23
Ref. 226 649-C