Care, Cleaning And Storage - Sage Smart Toast BTA825UK Instruction Booklet

OPERATING YOUR NEW APPLIANCE
The A QUICK LOOK™ button
4.
surround will illuminate in white
allowing you to check on the toasting
progress and, if necessary, cancel the
cycle by pressing TOAST/CANCEL
button when the desired toast colour is
achieved. Approximately 10 seconds
before the end of the selected browning
setting, the A QUICK LOOK™ button
will cease illumination.
As the toasting stops and the carriage
5.
rises, the TOAST/CANCEL button
surround will flash and the LED
toasting progress indicator will cease
flashing. The LED toasting progress
indicator will re-illuminate to the
previously selected browning setting.
Once the toasting cycle has finished
6.
and the carriage has risen and locked
into the raised position, the toast ready
alert will sound. Remove the toast. The
TOAST/CANCEL button surround
will re-illuminate in white for up to 30
seconds, ready for the next toasting
cycle. The FROZEN button surround
will remain illuminated and should be
pressed once to cancel if a subsequent
toasting function is required. The
FROZEN button surround will cease
to illuminate after 30 seconds or when
the appliance is switched off at the
power point. The FROZEN button
works for frozen crumpets/bagels as
well.
14
A QUICK LOOK BUTTON
™
This feature automatically raises and lowers
the carriage so you can check progress without
interrupting and/or cancelling the toasting
cycle.
To select this feature:
The A QUICK LOOK™ button surround
1.
will illuminate in white during the toasting
cycle and when using the A BIT MORE™
feature. You can press the A QUICK
LOOK™ button during toasting cycle to
view the toasting progress. If selected,
the A QUICK LOOK™ button surround
will flash. The LED toasting progress
indicator will cease to flash indicating that
the selected toasting cycle time has not
been interrupted. When the A QUICK
LOOK™ cycle has finished, the toasting
cycle will re-commence, indicated by the
resumed flashing of LED toasting progress
indicator.
Approximately 10 seconds before the
1.
end of the selected browning setting,
the A QUICK LOOK™ button will cease
illumination and cannot be activated in
this time.
PAGE HEADER..... CARE, CLEANING & STORAGE
CARE AND CLEANING
Switch the toaster off at the power
1.
outlet and then remove the power plug
from the power outlet. Allow the toaster
to cool completely before cleaning.
To clean any crumbs from the toaster,
2.
remove the crumb tray (located under
the control panel at the front of the
toaster) by pulling it outwards. Empty
and replace the crumb tray before
using the toaster again. Replace the
crumb tray by sliding it inwards until it
locks into position.
To remove any additional crumbs, turn
3.
the toaster upside down over a bin and
shake crumbs free.
Wipe the outside of the toaster with
4.
a slightly dampened soft cloth and
then dry it with a soft dry cloth to dry
completely.
NOTE
Do not clean with metal scouring pads.
Pieces can break off the pad and touch
electrical parts creating an electric
shock hazard.
STORAGE
Switch toaster off at the power outlet and
remove the power plug from the power outlet.
Allow the toaster to cool completely before
storing. Follow the directions for cleaning and
store in an upright position on a flat surface on
a bench top or in an accessible cupboard. Do
not store anything on top of the toaster.
WARNING
Do not use the toaster without the crumb
tray in position.
Do not allow crumbs to build up in
the crumb tray. Failure to clean the
crumb tray regularly may result in
a fire hazard.
15