Marantz AV8802A Owner's Manual page 30

Contents Connections
Q2 Q3 Q4 Q5
I NETWORK connector
Used to connect to a LAN cable when connecting to a wired LAN
network. (v p. 79)
J USB port
This is used to connect USB storages (such as USB memory devices)
and the USB cable supplied with iPod. (v p. 74)
K AC inlet (AC IN)
Used to connect the power cord. (v p. 84)
L FM/AM antenna terminals (ANTENNA)
Used to connect FM antennas and AM loop antennas. (v p. 77)
M BALANCED XLR IN terminals
Used to connect devices equipped with BALANCED XLR output
terminals. (v p. 68)
Front panel Display
Playback
o Q0
Q6 Q7 Q8 Q9
Rear panel
Settings
N FLASHER IN jack
Q1
Used when using a control BOX or other such control devices to control
this unit.
O REMOTE CONTROL jacks
Used to connect infrared receivers/transmitters in order to operate this
unit and external devices from a different room. (v p. 81)
P Digital audio connectors (DIGITAL AUDIO)
Used to connect devices equipped with digital audio connectors.
(v p. 47)
Q Balanced XLR OUT terminals
Used to connect a power amp with BALANCED XLR input terminals.
(v p. 46)
R DC OUT jack
Used to connect devices equipped with the trigger function.
(v p. 83)
S RS-232C connector
Used to connect home automation controller devices fitted with
RS-232C connectors. Consult the owner's manual of the home
automation controller for more information about serial control of this
unit.
Perform the operation below beforehand.
A Turn on the power of this unit.
B Turn off the power of this unit from the external controller.
C Check that the unit is in the standby mode.
NOTE
Do not touch the inner pins of the connectors on the rear panel. Electrostatic
discharge may cause permanent damage to the unit.
30 Remote
Tips Appendix
Index