Table of Contents
Advertisement
4. GETTING STARTED
4.1 RADIO CARE
Before following the instructions below, insure the battery pack is in place
and firmly connected. Care must be taken if the radio was dropped and a
close inspection may be needed to insure the radio case and gaskets are
in adequate condition.
The design of the HX380 allows water to enter between the radio and the bat-
tery pack, however waterproof performance is not compromised.
After using the HX380 in salt water environment is recommended to clean the
radio with fresh water by rinsing the battery and radio (separately) under a
sink facet or by dunking in a fresh water. After washing,use a soft cloth to thor-
oughly dry all parts of the radio and battery.
This will keep the radio parts and the battery clean and in top operating condition.
4.2 BELT CLIP INSTALLATION
Insert the mounting screw through the belt clip, and affix it snugly to the
mounting hole on the back of the transceiver.
Do not install the supplied Belt Clip Mounting Screws if you are not install-
ing the Belt Clip! Also, do not use an improper screw for mounting the Belt
Clip! An improper screw may cause a "short circuit" to the internal circuitry,
causing serious damage!
Page 12
CAUTION
CAUTION
Mounting Screw
Belt Clip Tab
HX380
Advertisement
Table of Contents
