Maserati QUATTROPORTE Owner's Manual page 39

To enter Remote Start Mode
NOTE:
On the remote control of vehicles with
this feature, the button is
replaced by the remote start button
.
Press and release the button
key fob RKE transmitter twice within
five seconds. The vehicle doors will
lock, parking lights will flash and the
horn will ring twice (if set). Then, the
engine will start and the vehicle will
remain in the "Remote Start" mode
for a 15-minute cycle.
NOTE:
• In case of an engine fault or low fuel
level, the vehicle will start and then
shut down in 10 seconds.
• The park lamps will turn on and
remain lit during "Remote Start"
mode.
• For security reasons, power window
and power sunroof operation (if
equipped) are disabled when the
vehicle is in the "Remote Start"
mode.
on the
• The engine can be started two
consecutive times (two 15-minute
cycles) with the key fob RKE
transmitter. However, the ignition
must be cycled to the RUN position
before you can repeat the start
sequence for a third cycle.
To exit Remote Start Mode
without Driving the Vehicle
Press and release the button
time or allow the engine to run for
the entire 15 minute cycle.
NOTE:
To avoid unintentional shutdowns, the
system will disable the one time press
of the button
receiving a valid "Remote Start"
request.
To exit Remote Start Mode and
Drive the Vehicle
Before the end of 15 minute cycle,
press and release the button
key fob RKE transmitter to unlock the
doors and disarm the vehicle security
alarm. Then, prior to the end of the 15
minute cycle, press and release the
START/STOP button.
NOTE:
The message "Push Start Button" will
display in the instrument cluster until
you push the START/STOP button.
Auto-On Comfort with Remote
Start
The driver's heated and ventilated
one seat and the heated steering wheel (if
equipped) can be programmed to
come on during a remote start. Refer
to "Auto-On Comfort & Remote Start"
function in chapter "MTC Setting",
section 4, for further information.
for two seconds after
Before Starting
on the
2
37