Maserati QUATTROPORTE Owner's Manual page 109

You can signal another vehicle with
your headlights by lightly pulling the
multifunction lever toward you. This
will turn on the high beams headlights
until the lever is released.
Flashing occurs also with lights off
(lights switch in position "0") if the
ignition switch is RUN position.
CAUTION!
The high beams can only be switched
on manually by pushing the left lever
forward.
WARNING!
If the high beams are activated, they
will turn on automatically every time
the low beams are switched on either
manually or automatically. We
recommend therefore that you switch
them off when they are no longer
necessary and every time the twilight
sensor deactivates the external lights.
Understanding the Vehicle
Entry/Exit Illumination
The compartment courtesy lights and
the exterior lights can be switched on
and off when entering or exiting the
vehicle by pressing the buttons on the
remote control and/or from the
Passive Entry System. Check
"Illuminated Entry/Exit" in section 2
for further information.
Interior Lights
The interior and external approach
lights turn on and off when
entering/exiting the vehicle (see
"Illuminated Entry/Exit" in section 2
for further information).
The brightness of the lights can be
manually adjusted with the regulator
positioned beside the multifunction
lever. To protect the battery, the
interior lights will turn off
automatically 10 minutes after the
ignition switch has been shifted to
OFF. This occurs if the interior lights
were turned on manually or by
opening of a door. The glove box
light, share the same characteristics
excepting the trunk light. To reset
interior lighting operation, either turn
the ignition switch out of OFF or
rotate the multifunction lever out of
"0" position.
3
107