Connecting To Weld Output Terminals - Miller Electric 250 Owner's Manual

.
A complete Parts List is available at www.MillerWelds.com

5-5. Connecting to Weld Output Terminals

1
6
3
4
5
Correct Installation
OM-217 455 Page 18
Do not place
anything between
weld cable terminal
and copper bar.
1 Work Weld Output Terminal
2 Electrode Weld Output Terminal
Connect work cable to Work terminal.
Connect electrode holder cable or
electrode weld cable to Electrode ter-
minal for Stick and MIG welding.
Connect torch cable to Electrode ter-
minal for TIG welding.
Use Process Selector switch to
select type of weld output (see
Section 6-2).
.
See Sections 6-3 thru 6-5 for typi-
cal process connections and
control settings.
!
Failure to properly connect
2
weld cables may cause exces-
sive heat and start a fire, or
damage your machine.
3 Weld Output Terminal
4 Supplied Weld Output Terminal
Nut
5 Weld Cable Terminal
6 Copper Bar
Remove supplied nut from weld out-
put terminal. Slide weld cable terminal
onto weld output terminal and secure
with nut so that weld cable terminal is
tight against copper bar. Do not
place anything between weld cable
terminal and copper bar. Make
sure that the surfaces of the weld
cable terminal and copper bar are
clean.
Incorrect Installation
Ref. 804 249-A / 228 647-A / 803 778-A
Tools Needed:
3/4 in