Table of Contents
Advertisement
6 Getting started
6.1 Switching on the MiniTIM
The MiniTIM gets activated performing an autotest when pressing the "X" key during 2 seconds.
During this autotest the device will make both leds blink in green and red color, will emit 3 beeps
and 2 vibrations. After this, the device will launch a 5 seconds scanner reading. With this reading
the user can configure several MiniTIM parameters if necessary, through a range of special
barcodes.
Then, MiniTIM, via the left LED, will indicate if it is already connected to a remote device. If there is
no connection to a remote device, the LED will flicker in green color.
NOTE: The initial configuration will be maintained if there is no new parameter configuration at this point.
6.2 MiniTIM connection to a remote device
In this mode the MiniTIM has to be searched by a remote device and be paired with it by Bluetooth
connection. If the user is required to introduce any password, it will be "0000".
The left LED will stop blinking and remain in a green color if the pairing is valid. At this moment any
barcode scanned by MiniTIM will be sent to the remote device.
8 de 14
Advertisement
Table of Contents
