Table of Contents
Advertisement
4 Operational modes
MiniTIM has several operational modes:
-
Initial mode-Inactivity.
-
Battery charge mode.
-
Normal operation mode:
o Scanner configuration mode.
o Scanner Bluetooth mode.
4.1 Initial mode-Inactivity
Once the battery is correctly installed in the MiniTIM, the device is in a initial suspension mode. In
this state, the MiniTIM, with a minimal battery comsuption, doesn't show any visual activity. To start
operational mode it is necessary to long press the "X" key.
4.2 Battery charge mode
Whenever the MiniTIM is connected to any USB serial port or USB charger, the battery will start to
charge. This new state will be notified by:
-
Left Led: permanently in red color.
-
Right Led: orange blinking each 4 seconds.
-
Little sound each 4 seconds.
Once the battery is completely charged the device will emit 3 beeps and the leds will switch off.
4.3 Scanner configuration mode
MiniTIM goes into this mode when the scanner configuration code is read. It allows to configure the
Imager scanner to adapt it to the final use desired, allowing also the configuration of all the
symbologies to be scanned, barcodes format, prefix and suffix if needed, etc.
This mode is made to configure the scanner through the reading of the needed barcodes included
in the user's guide.
5 de 14
Advertisement
Table of Contents
