Cadillac 2010 DTS Owner's Manual page 401

17. Return the equipment to its original storage
location in the vehicle.
18. Immediately drive the vehicle 5 miles (8 km) to
distribute the sealant in the tire.
16. If the flat tire was
able to inflate to the
recommended inflation
pressure, remove
the maximum speed
label from the sealant
canister and place
it in a highly visible
location. The label is a
reminder not to exceed
55 mph (90 km/h) until
the damaged tire is
repaired or replaced.
I n f o r m a t i o n P r o v i d e d b y :
19. Stop at a safe location and check the tire pressure.
Refer to Steps 1 through 11 under Using the Tire
Sealant and Compressor Kit without Sealant to
Inflate a Tire (Not Punctured).
If the tire pressure has fallen more than
10 psi (68 kPa) below the recommended inflation
pressure, stop driving the vehicle. The tire is too
severely damaged and the tire sealant cannot seal
the tire. See Roadside Service on page 8 7.
If the tire pressure has not dropped more than
10 psi (68 kPa) from the recommended inflation
pressure, inflate the tire to the recommended
inflation pressure.
20. Wipe off any sealant from the wheel, tire,
and vehicle.
21. Dispose of the used sealant canister and sealant/
air hose (F) assembly at a local dealer or in
accordance with local state codes and practices.
22. Replace it with a new canister available from your
dealer.
23. After temporarily sealing a tire using the tire
sealant and compressor kit, take the vehicle to an
authorized dealer within a 100 miles (161 km) of
driving to have the tire repaired or replaced.
6-81