Advertisement
Instruction Manual
P-TRONIC 40P
5. General description
This apparatus is a constant direct current (DC) generator, designed to cut
electro conductive materials (metals and alloys) by a plasma arc process. The
plasma gas is generated by using compressed air.
5.1 Front panel description P-Tronic 40 model
3
1
8
1
Output current knob: it sets the output cutting current
2
ON/OFF switch: it turns the apparatus on and off.
3
Manometer: it shows the air pressure (bar) during the cut – using the gas pressure
reducer knob, it must be positioned at 4,5 – 5,0 bars
4
Earth clamp socket
5
ON/OFF led: it lights up when machine is ON
6
Safety led : it lights up when the torch safety circuit is activated
7
Thermal and over-voltage led: it lights up in case of thermal problems or wrong volta
ge supply
8
Torch output
P-Tronic 40P
P-Tronic 40P
5
6
7
2
4
WARNING: the generator is equipped with a TER PT-80 plasma torch,
cod. ZO132AA 6 mt long. This torch has to be considered as integral
part of the generator and its functioning and safety are guaranteed
only with the original torch. For any spare parts refer to the appendix
list. The torch is equipped with a safety circuit which prevents any
accidental contacts with conductive elements: the generator does
not work if the safety circuit is activated.
Switch always the machine OFF when working on the torch.
6. Optional kit - Air reducer P-Tronic 40
The P-Tronic 40 generator is equipped with a manometer but the air pressure reg-
ulation must be set with a pressure reducer that has to be connected externally.
The optional kit "Pressure reducer P-Tronic 40" cod. Z0157AA consists in a pres-
sure reducer and relevant fixing hanger.
6.1 Assembling of the optional Pressure reducer P-Tronic 40 kit
Proceed as shown in the pictures:
Step 1:
Insert the hanger on the handle
P-Tronic 40P - 70 - 100
Step 2:
Rotate the hanger of about 90°
until the closing "click"
- 5 -
GB
Hide quick links:
Advertisement
