Advertisement
Instruction Manual
3.1 Technical specifications table
Technical data
Code
Main supply (-10%/+15%)
Frequency
Main power (60%)
Open current voltage V0
Current range I2
GB
Cutting current I2 (X%)
Cutting current I2 (60%)
Cutting current I2 (100%)
Recommended cutting capc.
Maximum cutting capacity
Severence cutting capacity
Gas pressure (torch 6 m.).
Insulation class
Protection degree
Dimensions
Weight
P-Tronic 40P
P-Tronic 70
V0042AA
VOO82AA
VAC
1Ph x 230V
3Ph x 400V
Hz
50/60
50/60
KVA
6 / ED50%
11
V
260
280
A
20 ÷ 40
20 ÷ 70
A
40A + ED50%
--------
A
36
70
A
25
55
mm
12
18
mm
20
25
mm
30
35
bar
4,5 ÷ 5
5,5 ÷ 6,0
F
F
IP
21S
21S
mm
310x180x480
360x350x630
Kg
9
25
4. Start-up and use
PTronic 100
The machine must be installed by qualified personnel. All connections must be
made in compliance with current safety standards and full observance of
V0059AA
safety regulations.
3Ph x 400V
4.1 Main supply connection
50/60
Connect the power cord A: the yellow-green cable wire must be connected to an
efficient grounding socket on the system. The remaining wires must be
16
connected to the power supply line by means of a switch placed as close as pos-
sible to the cutting area, to allow it to be shut off quickly in case of emergency.
310
The capacity of the cut-out switch or fuses installed in series with the switch must
20 ÷ 100
be equal to the current I1 absorbed by the machine. The absorbed current I1 may
be determined by reading the technical specifications shown on the machine
----------
under the available supply voltage U1 . Any extension cords must be sized
appropriately for the absorbed current I1.
100
75
22
30
40
5,5 ÷ 6,0
F
23
610x340x680
39
P-Tronic 40P - 70 - 100
- 4 -
Hide quick links:
Advertisement
