Memory configurations
You may install 2 GB, 4 GB, 8 GB, and 16 GB unbuffered and non-ECC DDR4 DIMMs into
the DIMM sockets.
•
You may install varying memory sizes in Channel A and Channel B. The system
maps the total size of the lower-sized channel for the dual-channel configuration. Any
excess memory from the higher-sized channel is then mapped for single-channel
operation.
•
According to Intel
the CPU.
•
Due to the memory address limitation on 32-bit Windows
or more memory on the motherboard, the actual usable memory for the OS can be
about 3GB or less. For effective use of memory, we recommend that you do any of the
following:
a)
Use a maximum of 3GB system memory if you are using a 32-bit Windows
b)
Install a 64-bit Windows
motherboard.
c)
For more details, refer to the Microsoft
com/kb/929605/en-us.
•
This motherboard does not support DIMMs made up of 512 Mb (64 MB) chips or less
(Memory chip capacity counts in Megabit, 8 Megabit/Mb = 1 Megabyte/MB).
•
The default memory operation frequency is dependent on its Serial Presence Detect
(SPD), which is the standard way of accessing information from a memory module.
Under the default state, some memory modules for overclocking may operate at a
lower frequency than the vendor-marked value. To operate at the vendor-marked
or at a higher frequency, refer to section 3.5 Ai Tweaker menu for manual memory
frequency adjustment.
•
For system stability, use a more efficient memory cooling system to support a full
memory load (4 DIMMs) or overclocking condition.
•
Always install the DIMMS with the same CAS Latency. For an optimum compatibility,
we recommend that you install memory modules of the same version or data code
(D/C) from the same vendor. Check with the vendor to get the correct memory
modules.
SABERTOOTH Z170 MARK 1
CPU spec, DIMM voltage below 1.65 V is recommended to protect
®
OS when you want to install 4 GB or more on the
®
®
OS, when you install 4GB
®
support site at http://support.microsoft.
OS.
®
1-11
Need help?
Do you have a question about the SABERTOOTH Z170 MARK 1 and is the answer not in the manual?
Questions and answers