Installation And Use; Preparing The Coffee - Victoria Arduino VENUS Installation And Use

INSTALLATION AND USE

1.Assemble the eagle, included in the
accessory box, over the dome .
2.Lift the dome and fill the white plastic tank
with potable
reassemble the dome.
3.Connect the power plug to a grounding type
power outlet.
4.Position the steam arm over the drain grill,
press the coffee delivery switch
at the same time, open the
stopcock by turning
notice the water exiting from the tube ,
close the stopcock again and wait for water
to exit from the unit as well. Switch off the
coffee delivery switch
5.Fasten the filter-holder cup to the unit by
turning from left to right.
6.Push "on/off" button and wait about five
minutes (the time required to heat the
machine).

PREPARING THE COFFEE

1.Release the filter holder by twisting from
right to left. 2 filters are provided , one
larger filter for two cups of coffee and a
smaller one just one cup of coffee. You will
also find a measure and press. For just one
cup , use the smaller filter, filling this with a
single measure dose. For two cups, use the
larger filter , filling this with two measure
ENGLISH
water, subsequently
, and,
steam unit
. When you
.
doses. Press the coffe down using the press
and then firmly fasten the filter-holder back
on by twisting from left to right.
2.Position the cup or cups under the outlets of
the filter holder and press the
switch. Once obtained the desired dose
coffee , turn of the coffee switch
USING THE STEAM UNIT
1.Turn the thermostat knob to
2.Open the steam unit stopcock to drain off all
the water into container. Close the stopcock
again and wait for about one minute.
3.Prepare whatever is to be heated (milk,
water, chocolate, etc.) .
4.Submerge steam unit tube and open the
stopcock. . Keep this open until the desired
temperature of the drink is reached.
Very important: After using the steam unit,
return the thermostat knob to initial position
and operate the coffee switch
and wait for water to exit from the unit.
coffee
.
position.