Sharp HT-SB400 Operation Manual page 25

• Subwoofer level control
The subwoofer level can be adjusted.
To increase the l evel, press the
SUBWOOFER LEVEL/X button.
To decrease the l evel, press the
SUBWOOFER LEVEL Vbutton. 5_ 4... _ +4_+5
Note:
When sound from the speaker isdistorted, decrease the
subwoofer level.
• Centre speaker level control
The centre speaker level can be adjusted.
To increase the l evel, press the c entre SPK
LEVEL/X button.
To decrease the l evel, press the c entre SPK
LEVEL Vbutton.
-5_-4 .... +4H+5
• Bass control
1. Press the BASS/TREBLE button
to seIect 'BASS". _ _5 5
2. Within 5 seconds, press the --->
VOLUME (+ or -) button to adjust
the bass. ,_
• Treble control
1. Press the BASS/TREBLE button
to select 'TREBLE". _ _5 +5
2. Within 5 seconds, press the -_
VOLUME (+ or -) button to adjust
the treble.
• Touch Sensing Off mode
During Stand-by mode, press the DIMMER/SENS ON/OFF
button on the remote control and the on/stand-by indicator wilt
turn from ORANGE to RED.
To turn the power on, press the ON/STAND-BY button on the
remote contro{ or touch the ON/STAND-BY pad on the display
panel.
• Function
When the FUNCTION pad on
speaker is touched or LINE 1 - 2
button on the remote control is
pressed, the input source witt
change. Touch the FUNCTION pad
on speaker or LINE button on the
remote control repeatedly to select
desired input source.
Note:
The backup function wilt protect the memorized function mode
for a few hours should there be a power failure or the AC power
lead becomes disconnected.
Auto power on function:
When you press the LINE button on the remote control, the
speaker witl turn on at last function.
Auto power off and auto detect signal:
The speaker will automatically off after 1 minute of inactivity.
The ON/STAND-BY indicator turns orange. At this point, it witl
automatically power ON if it detects audio signal from connected
equipment.
Note:
Make sure to turn off any source/signal input to speaker before
going to stand-by mode because it will cause the speaker to
power ON again.
HT-SB400
E-14