Table of Contents
Advertisement
Tuning into a station automatically
(Automatic Tuning)
1
Press TUNER repeatedly to
select the FM or AM band.
You can also use INPUT SELECTOR on
the receiver.
2
Press TUNING + or TUNING –.
Press TUNING + to scan from low to
high; press TUNING – to scan from high
to low.
The receiver stops scanning whenever a
station is received.
In case of poor FM stereo
reception
If the FM stereo reception is poor and "ST"
flashes on the display, select monaural audio
so that the sound will be less distorted.
Press FM MODE repeatedly until the
"MONO" indicator lights up on the display.
To return to stereo mode, press FM MODE
repeatedly until the "MONO" indicator on the
display lights off.
Tuning into a station directly
(Direct Tuning)
You can enter the frequency of a station
directly by using the numeric buttons.
1
Press TUNER repeatedly to
select the FM or AM band.
You can also use INPUT SELECTOR on
the receiver.
2
Press D.TUNING.
3
Press the numeric buttons to
enter the frequency.
Example 1: FM 102.50 MHz
Select 1 b 0 b 2 b 5 b 0
Example 2: AM 1,350 kHz
Select 1 b 3 b 5 b 0
32
GB
Tip
If you have tuned in an AM station, adjust the
direction of the AM loop antenna for optimum
reception.
4
Press ENTER.
If you cannot tune in a station
Make sure you have entered the right
frequency. If not, repeat steps 2 to 4. If you
still cannot tune in a station, the frequency is
not used in your area.
Changing the AM tuning scale
You can change the AM tuning scale to either
9 kHz or 10 kHz using the buttons on the
receiver.
?/1
?/1
TUNING MODE
TUNING
VIDEO IN/
A.F.D.
MOVIE
MUSIC
PORTABLE AUDIO IN
PHONES
TUNING MODE
1
Press ?/1 to turn off the
receiver.
2
While holding down TUNING
MODE, press ?/1.
3
Change the current AM tuning
scale to 9 kHz (or 10 kHz).
To reset the scale to 10 kHz (or 9 kHz),
repeat the procedure above.
Note
All preset stations will be erased when you change
the tuning scale.
MASTER VOLUME
DISPLAY
INPUT MODE
INPUT SELECTOR
Advertisement
Table of Contents
