Features; Before First Use; Operation - Nesco CC-32 Instruction Manual

Lid
Ice Shaving
Chamber
Shaft
Base
1. Read and understand all instructions and keep for future reference.
2. Remove all packaging and labels.
3. Clean all parts, except Base, following the instructions in the 'Care and Cleaning ' section.
NOTE: BE CAREFUL WHEN WIPING AROUND THE SHAFT, SHAVING BLADE IS SHARP.
4. Wipe the Base with a damp cloth. NEVER IMMERSE THE BASE IN WATER OR ANY OTHER
LIQUID.
1. Place base on a flat, stable surface. Be sure the unit is disconnected from electrical outlet
before installing or removing any components.
2. Place Shaving Chamber into Base and ensure it is seated on the Shaft (Fig. 1).
3. Twist shaft counter-clockwise to lock Ice Chamber into place (Fig. 2).
4. Place Mixing Paddle into Ice Bowl. (Fig 3). If mixing
with ingredients, put ingredients into Ice Bowl.
5. Insert Ice Bowl into groove on Base, lift slightly and
turn clockwise until it locks (Fig 4). This will allow
the mixing paddle to mix ice and ingredients while
operating.
6. Turn Selector Knob to desired crushed ice setting.
7. Place ice into Shaving Chamber, do not exceed
Maximum fill line. DO NOT USE WHILE EMPTY OR
WITHOUT ICE BOWL AND LID IN PLACE.
8. Plug cord into 120V electrical outlet.
9. Place Lid onto Base and turn counter-clockwise to
engage interlock switch (Power On/Off). The unit
will start and begin to shave ice.
10. Turn the Lid clockwise to stop. Remove Ice Bowl by
turning counter-clockwise to unlock and slide to remove.

FEATURES

BEFORE FIRST USE

OPERATION

2
Mixing
Paddle
Selector Control
Ice Bowl
FIG. 1 FIG. 2
FIG. 4
FIG. 3