Table of Contents
Advertisement
Symbol
Property or statement
BPm
Blows per minute
CFm
Cubic Feet per Minute flow
Cubic Feet per Minute flow
SCFm
at standard conditions
nPT
National pipe thread, tapered
nPS
National pipe thread, straight
WARNING marking
concerning Risk of Eye Injury.
Wear ANSI‑approved
eye protection.
WARNING marking
concerning Risk of
Hearing Loss. Wear
hearing protection.
WARNING marking
concerning Risk of Respiratory
Injury. Wear NIOSH‑approved
dust mask/respirator.
WARNING marking
concerning Risk of Explosion.
Specific Safety
Instructions
1.
The warnings and precautions
discussed in this manual cannot cover
all possible conditions and situations
that may occur. It must be understood
by the operator that common sense
and caution are factors which cannot
be built into this product, but must
be supplied by the operator.
WARNING: Some dust created by
power sanding, sawing, grinding,
drilling, and other construction activities,
contains chemicals known [to the State
of California] to cause cancer, birth
defects or other reproductive harm.
SKU 68832
For technical questions, please call 1-800-444-3353.
Some examples of these chemicals are:
• Lead from lead‑based paints
• Crystalline silica from bricks and
cement or other masonry products
• Arsenic and chromium from
chemically treated lumber
Your risk from these exposures varies,
depending on how often you do this
type of work. To reduce your exposure
to these chemicals: work in a well
ventilated area, and work with approved
safety equipment, such as those dust
masks that are specially designed
to filter out microscopic particles.
(California Health & Safety
Code § 25249.5, et seq.)
2.
WARNING: The brass components
of this product contain lead, a
chemical known to the State of
California to cause birth defects
(or other reproductive harm).
(California Health & Safety
code § 25249.5, et seq.)
3.
Only use with accessories rated to
handle the forces exerted by this tool
during operation. Other accessories
not designed for the forces generated
may break and forcefully launch pieces.
4.
Attach all accessories properly to
the tool before connecting the air
supply. A loose accessory may
detach or break during operation.
5.
Obey the manual for the air
compressor used to power this tool.
6.
Install an in‑line shutoff valve
to allow immediate control over
the air supply in an emergency,
even if a hose is ruptured.
7.
Use this tool with both hands only.
Using tools with only one hand
can result in loss of control.
8.
Do not lay the tool down until it has
come to a complete stop. Moving
parts can grab the surface and
pull the tool out of your control.
Page 5
Advertisement
Table of Contents
