Table of Contents
Advertisement
e.
Store the tool when it is idle out of
reach of children and other untrained
persons. A tool is dangerous in
the hands of untrained users.
f.
maintain the tool with care. Keep
a cutting tool sharp and clean. A
properly maintained tool, with sharp
cutting edges reduces the risk of
binding and is easier to control.
g.
Check for misalignment or binding
of moving parts, breakage of parts,
and any other condition that affects
the tool's operation. If damaged,
have the tool serviced before using.
Many accidents are caused by poorly
maintained tools. There is a risk of
bursting if the tool is damaged.
h.
use only accessories that are
identified by the manufacturer for
the specific tool model. Use of an
accessory not intended for use with
the specific tool model, increases
the risk of injury to persons.
i.
Always use proper guard with
Cut-off Tool. A guard reduces
the risk of injury to persons from
broken wheel fragments.
j.
Accessories must be rated for
at least the speed of the tool
marked on the tool label. Wheels
and other accessories running over
rated speed can fly apart and result
in a risk of injury to persons.
Service
a.
Tool service must be performed
only by qualified repair personnel.
b.
When servicing a tool, use only
identical replacement parts.
use only authorized parts.
c.
use only the lubricants supplied
with the tool or specified
by the manufacturer.
Page 4
For technical questions, please call 1-800-444-3353.
Air Source
a.
never connect to an air
source that is capable of
exceeding 200 psi.
Over pressurizing the tool
may cause bursting, abnormal
operation, breakage of the tool or
serious injury to persons. Use only
clean, dry, regulated compressed air at
the rated pressure or within the rated
pressure range as marked on the tool.
Always verify prior to using the tool that
the air source has been adjusted to the
rated air pressure or within the rated
air‑pressure range.
b.
Never use oxygen, carbon dioxide,
combustible gases or any bottled
gas as an air source for the tool.
Such gases are capable of explosion
and serious injury to persons.
SAVE ThESE
InSTRuCTIOnS.
Symbols and Specific
Safety Instructions
Symbol Definitions
Symbol
Property or statement
n
No‑load speed
o
Revolutions or
.../min
reciprocation per minute
Pounds per square
PSI
inch of pressure
ft-lb
Foot‑pounds of torque
Chart continued in next column.
SKU 68832
Advertisement
Table of Contents
