Tool Set Up; Work Piece And Work Area Set Up - CentralPneumatic 68832 User Manual

Operating Instructions
Read the EnTIRE ImPORTAnT
SAFETY InFORmATIOn
section at the beginning of
this manual including all text
under subheadings therein before
set up or use of this product.
Inspect tool before use, looking
for damaged, loose, and missing
parts. If any problems are found,
do not use tool until repaired.

Tool Set up

TO PREVEnT SERIOuS InjuRY
FROm ACCIDEnTAl OPERATIOn:
Turn off the tool, detach the air
supply, safely discharge any residual
air pressure in the tool, and release
the throttle and/or turn the switch
to its off position before performing
any set up, inspection, maintenance,
or cleaning procedures.
TO PREVEnT SERIOuS InjuRY:
Do not adjust or tamper with
any control or component in a
way not specifically explained
within this manual. Improper
adjustment can result in tool
failure or other serious hazards.
Adjusting the Guard
Rotate the Guard 360º in any direction
to position as needed before use.
Installing the Wheel
1. Use the Spanner to hold the
Spindle in place while, at the same
time, loosening and removing the
Socket Head Screw and Flange
with the Hex Key Wrench
SKU 68832
.
For technical questions, please call 1-800-444-3353.
Cutting Wheel
Flange
Socket
head Screw
hex key
Wrench
Figure 1
2. Place the cutting disc (sold separately)
onto the Spindle. The cutting disc
must be rated to at or above the
maximum speed of the Cut-off Tool
and must have a 3 In. diameter.
See specifications on page 7.
3. Use the Spanner to hold
the Spindle in place.
4. Insert the Socket Head Screw
through the Flange, through the
cutting disc, and into the Spindle.
5. Tighten the Socket Head Screw into
the Spindle with the Hex Key Wrench.
Adjusting the Exhaust
Rotate the Adjustable Exhaust
Ring 360º in any direction to
redirect the direction of exhaust.
Adjusting the Air Flow
Rotate the Four Level Air Control to
adjust the amount of air flow from
lowest to highest (1 to 4 on the Control).
Work Piece and
Work Area Set up
1. Designate a work area that is clean
and well‑lit. The work area must
not allow access by children or pets
to prevent distraction and injury.
Spanner
Spindle
Page 11