Table of Contents
Advertisement
2.
Route the air hose along a safe route
to reach the work area without creating
a tripping hazard or exposing the air
hose to possible damage. The air
hose must be long enough to reach the
work area with enough extra length to
allow free movement while working.
3.
Secure loose workpieces using a
vise or clamps (not included) to
prevent movement while working.
4.
There must not be hazardous
objects (such as utility lines or
foreign objects) nearby that will
present a hazard while working.
General Operating
Instructions
note: Make all set up adjustments to
tool before connecting air supply.
1.
If an automatic oiler is not used,
add a few drops of Pneumatic Tool
Oil to the airline connection before
use. Add a few drops more after
each hour of continual use.
2.
Mark the workpiece area
where you wish to cut.
3.
With both hands, grip the Cut‑off
Tool so that your thumbs rest on
the Throttle and Safety Lock.
4.
Keep the cutting wheel off the
surface of the workpiece until
it reaches operating speed.
5.
Press the Safety Lock forward while
pressing down on the Throttle.
nOTE: The Cut‑off Tool's speed is
variable. Vary the pressure placed
on the Throttle to vary the speed of
the tool. Use only enough speed
as needed to cut the workpiece.
6.
Slowly and carefully place the
edge of the cutting wheel onto
the surface of the workpiece.
Page 12
For technical questions, please call 1-800-444-3353.
7.
Keep steady pressure on the Cut‑off
Tool. But do not force the tool, as you
will stall the Cut‑off Tool. Use only
enough pressure to do the job properly.
8.
If the tool requires more force
to accomplish the task, verify
that the tool receives sufficient,
unobstructed airflow (CFM) and
increase the pressure (PSI) output.
If the regulator up to the maximum
air pressure rating of this tool.
CAuTIOn! TO PREVEnT InjuRY
FROm TOOl OR ACCESSORY
FAIluRE:
Do not exceed the tool's
maximum air pressure rating
of 90 PSI.
If the tool still does not have sufficient
force at maximum pressure and
sufficient airflow, then a larger tool may
be required.
9.
To prevent accidents, turn off the tool,
detach the air supply, safely discharge
any residual air pressure in the tool,
and release the throttle after use.
Clean external surfaces of the tool
with clean, dry cloth, and apply a thin
coat of tool oil. Then store the tool
indoors and out of children's reach.
SKU 68832
Advertisement
Table of Contents
