Chevrolet 2016 SS Sedan Owner's Manual page 197

196 Infotainment System
3. Select Device List.
4. Select the new phone to
connect to and follow the
screen prompts.
Pairing with Voice Recognition
A Bluetooth-enabled cell phone
must be paired and then connected
to the vehicle before it can be used.
See the cell phone manufacturer's
user guide for Bluetooth functions
before pairing the cell phone. If a
Bluetooth phone is not connected,
calls will be made using OnStar
Hands-Free Calling, if available.
See OnStar Overview 0 375
Pairing a Phone
1. Press / . The system
responds Please say a
command, followed by a tone.
2. Say Pair. The system
responds with Please search
for Bluetooth devices on your
phone, select your vehicle,
confirm and enter the PIN
provided on the screen.
3. Start the search for Bluetooth
devices on the phone. Then
select the device and follow the
instructions on the phone by
either entering the four-digit
PIN or confirming the six-digit
passcode. The PIN is used in
Step 4.
4. Locate and select the device
named after the vehicle make
and model in the list on the cell
phone. Follow the instructions
on the cell phone to enter the
PIN provided in Step 3 or to
confirm the six-digit code
matches. The system responds
.
ii
successfully paired.
5. Repeat Steps 1 4 to pair
additional phones.
Listing All Paired and Connected
Phones
The system can list all cell phones
paired to it. If a paired cell phone is
also connected to the vehicle, the
system responds with is connected
after that phone name.
1. Press / . The system
responds Please say a
command, followed by a tone.
2. Say Device List.
Deleting a Paired Phone
If the phone name to delete is
unknown, see Listing All Paired
and Connected Phones.
1. Press / . The system
responds Please say a
command, followed by a tone.
2. Say Delete Device.
3. The system responds with: To
delete a device, please touch
its name on the screen. Select
the device to delete on the
display and it will be removed.
To cancel this command,
press / on the steering wheel
/
control or press the BACK button
on the radio faceplate.